Pedestal Base for Fly Tying Vise

by: Griffin Enterprises | Item#: OF-900760-0000
Got a Question?
3 Reviews  |  Write a Review
Add To Wishlist


A heavy cast base just under four pounds, with a rubber pad on the bottom. Works great for Griffin's lower priced c-clamp vises or any vise with a 3/8 inch stem.

Shipping Info

Overweight item - surcharge may apply for expedited or international shipping.


Average Customer Rating: (3 Reviews) Write a Review

Sort by:

Accepts 3/8" Stem only after some drilling

Reviewer: from Brevard, NC US

I have a Danvise which has a 3/8" stem. I had to drill out the hole on pedestal to fit the stem into it. Otherwise it appears that it will do the trick.
<i>J. Stockard comment: Actually the Danvise stem is 10mm which is a little larger than the standard 3/8" vise stem, hence the need for reaming the pedestal base hole.</i>

7 of 8 people found this review helpful. Do you? Yes No

Solid Vise Base

Reviewer: from Ann Arbor, MI US

This base provides a solid platform for fly tying. It holds my vise well with minimal movement while tying and the rubber bottom protects my table from scratches. The tightening knob is plastic, but seems solid enough.

5 of 5 people found this review helpful. Do you? Yes No

good heavy base

Reviewer: from Columbus, Ohio

Good heavy base that supports your vise as well as not moving around when you have a magnifier attached to the vice stem. Much better than the original base that came with my apex vise. My only complaint was I had to glue part of the rubber skid pad back on.

1 of 1 people found this review helpful. Do you? Yes No  Certified buyer
Mi9 Retail